RF-28 V4.1 Alu RC Car 1:28 Silver Edition
The Next Step by RACE-FACTOR:
RF-28 v4.1 1:28 Mini Rc Car
RC functions: steering, throttle / brake
The RF-28 v4.1 chassis was designed with performance in mind. The rear axle is designed as a spring-loaded Powerpod, so the chassis is very flexible. The drive battery is located across the chassis, which means that the center of mass is very low. As a result, very high cornering speeds can be achieved. The newly developed front axle geometry gives the chassis maximum mechanical grip and perfect traction in every driving situation.
A technical treat is the electronics to be installed in the chassis, now it is possible to install all alternative electronics in the chassis, here you are no longer branded. On the front axle, a high-resolution digital servo can be used, which transmits the steering commands to the transmitter in a split second on the wheels.
The front wheels are individually suspended and sprung, here the suspension can be adjusted perfectly for each route. In combination with the extremely low center of gravity, it achieves breathtaking driving dynamics that have never before been achieved on models of this size.
Ready assembled chassis (without diff, motor, other electronics)
Sophisticated front axle geometry with a lot of mechanical grip and direct steering behavior
Chassis compl. made of 1.5mm Alu 7075 T6
Technical data vehicle
Length *: 124-133 mm; Width *: 65-76 mm; Height: 35 mm; Trace (v & h) *: 56.5-63.0 mm; Wheelbase *: 98mm; Tire (v): Ø25x8,5 mm; Tire (h): Ø25x8,5 / 11 mm; Weight: approx. 100 g; Motor: PN brushless; Chassis Carbon 1.5mmThe technical data refer to the chassis without body! Because the chassis is variable in length, width, and tire, minimum and maximum values ??are given for some dates.
RF28v4.1 chassis made of 7075 T6 aluminum black anodized
Knuckle with -0.5 ° Optional up to -2 °
Front Spring Kit Optional Spring Kit
Carbon front drones
Motorböcke incl. Ball bearing (height adjustable)
Steering linkage adjustable
Adapter servo horn Graupner DES281
Body mount front and rear
What else is needed?
Differential (recommendation PN Racing)
Motor (recommendation PN Racing 3500KV-9500KV)
Receiver (MIcro LOCO)
Motor controller ESC (recommendation M-Radon)
Servo (recommendation DES281)
Rims (front 0 offset, rear +3 offset)
Ball bearings for rims
Tires depending on the track
Body Hold for Lexan Checks
My setup recommendation:
Differential: PN ball diff or cone diff (LM diff can also be mounted)
Engine: PN brushless 5500kv to 9500kv (my favorite engine 7500kv)
Controls: Team Power M-Radon ESC 20A
Servo: Graupner DES281BB MG
Battery: 2s 300mah Nano Tech
Tires: depending on the track (Marka sponge rubber silicone)
Material 1.5mm Alu 7075 T6 Made in Germany, powered by RACE-FACTOR